After the worm gear reducer has been placed for a certain period of time, especially during the rainy season, the worm gear reducer gets wet, resulting in a decline in its performance and affecting production efficiency. So, how can the worm gear reducer be protected from moisture? The following will be explained by the experts of the worm gear reducer. Hopefully, it will be helpful to everyone.
\nExternal heat source heating measures
\nAfter disassembling and inspecting the wet worm gear box, place the high-power incandescent lamp into the baking gear motor, or put the machine gear motor into the drying chamber for drying. This method is easy to use and reliable. However, they are suitable for small gearboxes that are easy to disassemble and inspect.
\n2. Measures for drying the welding machine
\nBefore using the AC welding machine drying method, connect the 6 wires of the wet gearwheel in series and ground it to make all three coils heat up and dry. To monitor the changes in current during the drying process, you can connect it in series with an ammeter and observe whether the current reaches 60% to 70% of the rated current in the gearbox. Using an AC welding machine to dry the gearbox does not require disassembling or inspecting the gear motor of the Taiwanese machinery.
\n3. D.C. welding machine drying measures
\nThe drying operation wiring of a direct current welding machine is similar to that of an alternating current one. The current meter series must be a direct current meter. Using a direct current welding machine for drying and dehumidification is easy to operate and can dry large and medium-sized machinery pressure reducers and high-pressure pressure reducers in Taiwan for a long time.
\n4. Drying measures for the excitation coil pipe
\nThe method for drying the excitation coil is to wind the excitation coil around the iron core of the stator coil. Through alternating current, magnetic flux is generated in the stator, and the stator of the deceleration motor is dried according to the iron loss.
\nThe above four points constitute the entire content of the moisture-proof measures for the worm gear and worm reducer. Thank you for your understanding and support!<\/p>\n","protected":false},"excerpt":{"rendered":"